The SHO-ME 11.1005STT.CHG / 11.1005STT.BTL 2011+ Dodge Charger LED Flasher has been specifically engineered and manufactured by SHO-ME to engage the factory installed LEDs lights on the center trunk section of the 2011+ DODGE CHARGER. This Stop Turn Tail style flasher is installed in-line with the Dodge Charger's existing lighting and brake system to cause the factory trunk lighting system to flash upper-lower while your emergency lights are engaged as well as cease flashing and act as a full brake light when the brake pedal is depressed. The flasher can be installed in about 30 minutes or less and should be installed only by those familiar with vehicle wiring and 12V systems. The 11.1005STT.BTL and 11.1005STT.CHG each features 10 flash patterns. Made in the USA.
Able 2 Products Company warrants each new product (except bulbs, strobe tubes, strobe power supplies and all LED products - see chart below) to be free from defects in material and workmanship for a period of two years from the date of purchase. During this warranty period, the obligation of Able 2 is limited to repairing or replacing, as Able 2 may elect, any part or parts, which after examination by Able 2 are determined to be defective, when they are delivered pre-paid. This limited warranty does not cover travel expense, the cost of specialized equipment for gaining access to the product, or labor charges for the removal and re-installation of the product.
Able 2 Products Company shall not be liable for incidental or consequential damages, including but not limited to: Loss of Vehicle, Rental of Substitute Vehicle, Loss of Time, Loss of Work, Inconvenience, Transportation Expenses, Telephone, Lodging, Loss of Revenue, Loss of and/or Damage to Personal Property for or arising out of breach of any express or implied warranty of its products.
Use of lamp or other electrical load of a wattage higher than installed or recommended by the factory, or use of inappropriate or inadequate wiring or circuit protection causes this limited warranty to become void. Able 2 Products Company will in no way be liable for any loss of profits or any indirect or consequential damages arising out of any such defect in material and workmanship whether loss is due to negligence or breach of warranty. This limited warranty does not apply to shipping damage, accident, alteration, tampering, misuse or abuse and unauthorized service.
This limited warranty is expressly in lieu of all other express or implied warranties, including the implied warranty of merchantability and the implied warranty of fitness for a particular purpose, and of all other obligations or liabilities on the part of Able 2 Products Company. There are no warranties, unless expressed in authorized Able 2 literature, which extend beyond the description of the face hereof. No dealer, distributor, employee, or representative of the company is authorized to change this warranty in any way or to grant any other warranty.
All LED Products 5 Years
Potted Strobe Power Supplies 2 Years
T Model Strobe Power Supplies 2 Years
All other Strobe Power Supplies 5 Years
All Other Products (EXCEPT Bulbs) 2 Years (under normal use)
Strobe Tubes 1 Year (under normal use)
Easy install. I wish this had been around when the car was new. helped the rear visibility a lot. I liked the "additional" instructions on your web page much better that the ones that came with the product.
Great product, poor instructions
Posted by Johnny on 27th Feb 2015
I purchased and installed this Sho-me flasher to my 2013 civilian Dodge Charger. The instructions are pretty straight forward and simple to understand until you reach the last step of the blue wire (connect it to the two wires that are hot when the running lights are on. Those wires are located at the left and right brake light housings which is not noted in the instructions. Pull the inner trunk liner back to locate the 4 wired plugs to find the hot wire) Also there is no trouble shooting guide with the instructions. The flasher that I installed works fine except the passenger side rear running light flashes when the Sho-me flasher is switched on (vehicles normal brake, turn signal, and running lights function just fine). I'm still trying to solve the problem of the rear passenger side running light which flashes when the switch is activated. If anyone had this same issue some help would be appreciated. Clear concise instructions possibly with pictures would be nice.
Posted by Unknown on 17th Jan 2014
Highly recommended. I've installed several of these on civilian chargers turned police vehicles. Zero problems or complaints. Brake light function over ride (stops) the led flashing so I recommend a set of led strobes in the reverse light housing to have something flashing at all times..